iPhone 3gs/4s 'Charging is not supported with this accessory' [How To Fix]
How to fix iPhone 3gs / 4s charging is not supported with this accessory:
if you are facing this annoying situation with your iPhone 3gs or iPhone 4s or iPod, you can try your luck fixing this annoyance with following few methods
Methods 1:
1. Turn the brightness all the way up then plug your device an check.
Method 2:
1. Plug in your charger.
2. When the message pops up "Charging is not supported with this accessory" press dismiss and hold it.
3. While holding dismiss, unplug the charger from the iPhone not the wall, and put it back in
it should work now.
Method 3:
Do a clean up.
1. Try blowing in both end and the iPhone charging whole or how your call it.
2. If you have the wall charger the one were you have to connect usb to it and plug to wall try taking a tooth brush add perfume on it not a lot and brush the wall charger.
Method 4:
Insert USB cable, while inserting USB cable in the USB port of computer or laptop, insert it to the point where you can hear a beep, leave it at that point. It should start charging without giving you any errors!
Method 5:
Plug out the charger first. Then turn on 'Airplane Mode'. Then plug-in charger again and check
it should start charging without giving you any errors!
Method 6:
Turn off your iPhone / iPod when its done then plug-in your charger, i hope it will work now without giving any error!
That's it.
Please do comment if you like this post :)
if you are facing this annoying situation with your iPhone 3gs or iPhone 4s or iPod, you can try your luck fixing this annoyance with following few methods
Methods 1:
1. Turn the brightness all the way up then plug your device an check.
Method 2:
1. Plug in your charger.
2. When the message pops up "Charging is not supported with this accessory" press dismiss and hold it.
3. While holding dismiss, unplug the charger from the iPhone not the wall, and put it back in
it should work now.
Method 3:
Do a clean up.
1. Try blowing in both end and the iPhone charging whole or how your call it.
2. If you have the wall charger the one were you have to connect usb to it and plug to wall try taking a tooth brush add perfume on it not a lot and brush the wall charger.
Method 4:
Insert USB cable, while inserting USB cable in the USB port of computer or laptop, insert it to the point where you can hear a beep, leave it at that point. It should start charging without giving you any errors!
Method 5:
Plug out the charger first. Then turn on 'Airplane Mode'. Then plug-in charger again and check
it should start charging without giving you any errors!
Method 6:
Turn off your iPhone / iPod when its done then plug-in your charger, i hope it will work now without giving any error!
That's it.
Please do comment if you like this post :)
Categories
:
Tips & Tricks
0 comments :
Post a Comment